User's Manual

AD Plus2.0 User Manual
Page 43 of 66
Serial Port: Select the peripheral you want to connect. The baud rate is filled by the
corresponding value automatically. If the baud rate is incorrect, modify it manually.
Note: If the AD Plus2.0 is connected to an R-Watch, the usage of 232-1 serial port
must be set to Rwatch on this screen.
Tap Preferences > Collection > General > CAN. The CAN setting screen is
displayed as follows:
On this screen, you can configure the function type and Baud rate of the CAN to be
accessed.
Tap Preferences > Collection > General > Speed. The Speed setting screen is
displayed as follows:
1. Unit: Set the unit of vehicle speed, unit: km/h or MPH.
2. Source: Select Satellite, Pulse, OBD, or Mix.

When Satellite or OBD is selected, the screen is shown as below: