User's Manual

AD Plus2.0 User Manual
Page 42 of 66
1) Normal: normal recording, algorithm recognition
2) Calibration: The camera is calibrated during installation. Algorithm
recognition-based alarming is not supported in this mode.
2.7.4. Camera Setting
In this module, you can flip, mirror, and rotate the cameras in all channels. Tap
Preferences > Surveillance > Camera Setup, as shown in the following figure:
On the lower left corner of the screen, select the target channel to set the rotating
angle of the camera in this channel, and enable or disable mirroring and flipping for
the camera.
2.8. Data Collection
In this module, you can set serial port, CAN, speed, location, and milestone
parameters.
2.8.1. General Setting
On the General screen, you can set parameters related to the serial port, CAN, speed,
location, mileage, and A-GPS.
Tap Preferences > Collection > General > Serial Port. The Serial Port setting
screen is displayed.