User's Manual

STRATTEC Security Corporation
FCC ID OHT05918179
IC 5461A-0591879
Page 6 of 8
Press and release to turn on the vehicle for cabin pre-conditioning. This
function will allow the user heat/cool the vehicle before entry.
7.) Opens the plug-in door
Press and release to access the plug-in door, located on the outside of the
vehicle.
Notes: If any of the buttons are pressed and not released within 60 second duration the RF
transmitter will stop transmitting and shut down to prevent the battery drainage.
Power Supply:
The RF transmitter is battery powered with 1 Lithium battery CR 2032, supplying +3V
power, which is installed into the PCB battery holder facing + side down.
The display in the instrument cluster of the vehicle will inform the user when the battery
of the RF transmitter is getting low (weak). The battery indicator light in the instrument
cluster flashes when the battery voltage level is decreasing to a lower than 2.3 V, the
battery should be replaces.
The minimum operating voltage is approximately 2.1 V. If the voltage drops below 2.1 V
the RF transmitter will not operate and battery needs to be replaced.
Battery:
Replacing the battery: