2.4 GHZ WIRELESS VIDEO SENDER WITH IR EXTENDER This product broadcasts over public airwaves and its video and audio signals may be intercepted without your consent. FOR MORE INFORMATION WWW.STRATEGICVISTA.COM Before operating the system, please read this manual thoroughly and retain it for future reference.
CAUTION RISK OF ELECTRIC SHOCK. DO NOT OPEN. ! CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. Explanation of two Symbols The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage“ within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
SAFETY INSTRUCTIONS IMPORTANT SAFEGUARDS All the safety and operating instructions should be read before the system is operated, and retained for future reference. 1. HEED WARNINGS - All warnings on the appliance and in the operating instructions should be adhered to. 2. FOLLOW INSTRUCTIONS - All operating instructions should be followed. 3. WATER AND MOISTURE - Do not use this video product near water – for example, a bath tub, wash bowl, kitchen sink, laundry tub or swimming pool, or in a wet basement. 4.
TABLE OF CONTENTS PAGE INTRODUCTION & FEATURES……………………………………… 1 SYSTEM INCLUDES………………………………………………….. 2 CONTROLS AND FUNCTIONS Wireless Transmitter…................….……………………..……... Wireless Receiver...……..............................……….……...…… 3 4 INSTALLATION OF WIRELESS TRANSMITTER…………………. 5 INSTALLATION OF WIRELESS RECEIVER Operation with TV (Using RCA Cables)......……………….….... Operation with TV (Using Coaxial Cable) ..............…..……......
INTRODUCTION: FEATURES: • Send signal to a second TV Satellite, DVD, or Security Camera • Change TV Functions from remote location using remote control extender • View video from another room • 300 ft Wireless Transmission (open space) • 2.
SYSTEM INCLUDES: 1 - 2.4 GHz Wireless Receiver 1 - 2.
CONTROLS & FUNCTIONS WIRELESS TRANSMITTER 2 TOP VIEW 3 REAR VIEW 5 4 6 7 8 1 9 BOTTOM VIEW Location of Transmitter controls . 1. Channel Selector Button – Used to select between channels 1-4 2. LED Channel Indicators – Indicator light shows selected channel . 3. IR Antenna - Extends the effect range between the receiver and the transmitter for the remote control feature 4. 2.4 GHz Antenna – High gain dipole antenna transmits audio and video signal to the wireless receiver 5.
CONTROLS & FUNCTIONS WIRELESS RECEIVER 2 TOP VIEW 3 REAR VIEW 4 5 6 7 8 1 9 10 BOTTOM VIEW Location of Receiver controls 1. Channel Selector Button – Used to manually switch channels from 1-4 2. LED Channel Indicators – Indicator light shows selected channel 3. IR Antenna - Extends the effect range between the receiver and the transmitter for the remote control feature 4. 2.4 GHz Antenna – High gain dipole antenna receives audio and video signal from the wireless transmitter 5.
INSTALLATION OF TRANSMITTER CONNECTING A TRANSMITTER SIGNAL FROM YOUR SATELLITE/TV STEP 1: Rear of Satellite/TV Back of Transmitter Electrical Outlet RCA Cable (Supplied) NOTE Ensure the Power Switch on the Transmitter is turned OFF prior to proceeding with the following steps. 1. Connect one end of the RCA cables to the Audio/Video Input jacks of the Transmitter; the other end to the Audio/Video Out jacks of the TV/Satellite/DVD.
INSTALLATION OF RECEIVER CONNECTING A RECEIVER TO A REMOTE TV USING RCA CABLES STEP 2: You have two options to connect the Receiver: A) Using RCA Cables (see below), or B) Coaxial Cables, please refer to page 7of this manual. A) Television Back of Receiver Electrical Outlet NOTE Ensure the Power Switch on the Receiver is turned OFF before proceeding with the following steps. 1. Place the wireless receiver near your television (or monitor). 2.
INSTALLATION OF RECEIVER CONNECTING A RECEIVER TO A T.V. USING COAXIAL CABLES B) Television Back of Receiver Electrical Outlet Audio Video Coaxial Cable (75 ohm) NOTE Ensure the Power Switch on the Receiver is turned OFF prior to proceeding with the following steps. 1. Place the wireless receiver near your television (or monitor). 2. Connect one end of the coaxial cable to the back of the Receiver. Plug the other end of the coaxial cable to the television. 3.
SYSTEM OPERATION CONNECTING MORE VIDEO DEVICES TO YOUR SYSTEM (MAX. OF 4) The Video Sender system allows you to connect more than 1 transmitter and receiver. Connecting more than one transmitter to the system is normally utilized when viewing multiple Video sources on a television or monitor. You also have the option to connect multiple receivers to this system for viewing your Satellite/DVD picture from multiple rooms.
SYSTEM OPERATION HOW TO USE THE IR EXTENDER ACCESSORY The IR Extender connects to the transmitter through its own special connector plug. The extender emits an IR signal to your A/V device with the remote signal. To use the IR extender, follow the instructions below; 1. Plug the IR Extender into the back of the transmitter (see page 3) 2. Orient the end of the IR Extender so that it points in the general direction of the IR sensors on the source device that you wish to control 3.
TROUBLESHOOTING If the system does not function properly, check the following points before contacting the service center.
TECHNICAL SPECIFICATIONS WIRELESS TRANSMITTER Power supply Current consumption Channel frequency Channel selection Modulation system Video channel Video input level Audio channel Audio input level Antenna type LED indicator IR Control Distance IR Transmission Angle Dimensions Weight AC adapter 9V DC 500mA output 150 mA TYP. 2.411 – 2.473 GHz 4 channel FM modulation 1 1 Vpp @ 75 Ohm 1 1 Vpp @ 600 Ohm Dipole Power > 3 meters 30 degrees 5.25”(Diameter) x 1.5” (Height) 136 grams or 4.
CARE AND MAINTENANCE: Please follow these instructions to ensure proper care and maintenance of this system Keep your monitor and camera dry. If it gets wet, wipe it dry immediately. Use and store your unit in normal temperature environment. Extreme temperatures can shorten the life of the electronic devices. Handle the monitor carefully. Dropping it can cause serious damage to the unit. Occasionally clean the unit with a damp cloth to keep it looking new.
