User's Manual Part 2

STRATEGIC Technologies Inc. Active Mode Installation
7. Install Strap and PID: Replace the baseplate and strap around the leg, and attach the
narrow end that has been cut to length to the baseplate. Push the PID into the baseplate at
the strap end. The PID is now hinged to the baseplate. Firmly close the PID and baseplate
together by pushing down on the open end.
Figure 5 : Attach the PID to the baseplate
8. Install Locking Mechanism: Insert the slider bar under the strap into the hole in the side of
the PID (See Figure 6 : Slider Bar) so the end of the slider bar is flush with the strap. Press
a pin through the hole in the strap and into the slider bar. This locks the PID together.
Figure 6 : Slider Bar
9. Check Strap Tightness: Check the strap tightness on the side opposite the PID. There
should not be a space of more than ½ inch or 1.4 centimetres between the strap and the
skin.
Installation Completion
10. Reset the PID: When the PRU+ has received a signal from the PID, the display on the
PRU+ should prompt “Check strap”. Use the LOCK’s PID button to reset the alarms
on the PID. If the alarms have been properly reset, the PRU+ will prompt “Everything ok,
Calling in now” and will immediately start to call into the Central Computer
11. Installation complete: When “Call Successful” is displayed, installation is complete.
PRU Installation - Classic