User's Manual Part 2

STRATEGIC Technologies Inc. Active Mode Installation
PID Installation
Figure 3: Installing the battery in the PID
Transmitter - showing battery well
Battery
5. Install the Battery: Remove the PID , baseplate, one strap, one locking bar, one locking
pin and the battery from the case. Simply place the battery into the PID battery well so that
the alignment mark on the battery lines up with the alignment mark on the PID. Rotate the
battery counterclockwise until the tabs on the battery slide under the two lock down posts.
(See Figure 3 : installing the battery in the PID).
6. Size the Strap: Attach the wide end of the strap to the PID baseplate. With the baseplate
on the outside of the leg, wrap the strap around the participant’s leg, just above the ankle.
Size the strap so that it fits comfortably around the participant’s leg. Cut off any excess
strap that is above the two hole positions that will fit into the other side of the strap (See
Figure 4 : Strap installation)
Figure 4 : Strap Installation