User's Manual Part 2

STRATEGIC Technologies Inc. Active Mode Installation
Active Mode Installation
These instructions should be used if the participant is to be monitored via a telephone line in the
participant’s residence. The PRU+ will call into the Central Computer on a regular basis reporting
all activity.
Pre-Installation
A. If your equipment is monitored by our Monitoring Center:-
- Fax the Enrollment Form to the Monitoring Center, giving as much time as possible before
the PRU+ is to be installed at a participant’s residence. The Monitoring Center must be
notified before the PRU+ calls in. See Passive Mode Operation (See Page 24) for more
details on installation of a PRU+ in a passive monitoring situation.
B. If you monitor your own equipment:-
- Assure you have entered the participant data on your system before you install the PRU+
in the participant’s residence. See Passive Mode Operation (Page 24) for more details on
installation of a PRU+ in a passive monitoring situation.
PRU+ Installation - Quick Install
Use this method if you are going to use the Quick Install Feature found in Firmware Version 2.1.
1. Position the PRU+: Remove the PRU+ and AC power adapter from the case. Place the
PRU+ in a central location, preferably closer to the participant’s bedroom than their living
area, elevated at least three feet / ninety centimetres from the floor.
2. Plug in the PRU+: Plug one end of the AC power adapter into a standard 110 Volt
electrical outlet and the other end into the PRU+. Note : Do not connect the telephone
line. The PRU+ will turn on, displaying the title screen. It will then display the date and time
screen. The power and charge LED will be lit. The charge LED will go out when the PRU+
internal battery is fully charged.
3. Clear Stored Events: Press and hold the PRU+ button on the LOCK until the PRU+
prompts “Please Wait....”. When the display prompts “B=Function Mode” press “B” button
once. The display will prompt “B=Clear Events”. Press “B”, the display will now prompt
“A=** Clear ** / B=Cancel”. Press “A” to clear all events.
4. Enter Quick Install: Press “A” button once. When the display prompts “B=Quick Install”,
press the “B” button to enter Quick Install. Follow the messages on the top line. Plug the
telephone line into the jack marked LINE on the back of the PRU+. The display will then
prompt “Waiting for PID”