User's Manual Part 2

STRATEGIC Technologies Inc. Passive Mode Installation
7. Install Locking Mechanism: Insert the slider bar under the strap into the hole in
the side of the PID (See Figure 6 : Slider Bar) so the end of the slider bar is flush
with the strap. Press a pin through the hole in the strap and into the slider bar. This
locks the PID together.
Figure 6 : Slider Bar
8. Check Strap Tightness: Check the strap tightness on the side opposite the PID.
There should not be a space of more than ½ inch or 1.4 centimetres between the
strap and the skin.
Installation Completion
9. Reset the PID: Once a signal has been received, the display should prompt “Check
strap” Use the LOCK’s PID button to reset the strap tamper on the PID. If the strap
sever has been properly reset, the PRU+ will prompt “Everything ok, Calling in now”
and will immediately start to call into the Central Computer
10. Complete the Installation: When “Call Successful” is displayed, initial setup is
complete.
11. Position the PRU+: Remove the PRU+ and AC Adapter. Place the PRU+ in a
central location, preferably closer to the participant’s bedroom than their living area,
elevated at least three feet / ninety centimetres from the floor. Assure that the PRU+ is
plugged into AC power when it reaches the participant’s home (be careful that the AC
outlet that the PRU+ is plugged into cannot be switched off with a light switch).