User's Manual Part 2

STRATEGIC Technologies Inc. Passive Mode Installation
Figure 3:
Installing the
battery in the
PID
5. Size the Strap: Attach the wide end of the strap to the PID baseplate. With the baseplate on
the outside of the leg, wrap the strap around the participants leg, just above the ankle. Size
the strap so that it fits comfortably around the participant’s leg. Cut off any access strap that is
above the two hole positions that will fit into the
other side of the strap (See Figure 4 : Strap
installation)
Figure 4 : Strap Installation
6. Install Strap and PID: Replace the baseplate and strap around the leg, and attach the narrow
end that has been cut to length to the baseplate. Push the PID onto
the baseplate at the strap end. The PID is now hinged to the
baseplate. Firmly close the PID and baseplate together by pushing
down on the open end.
Figure 5 : Attach the PID to the
baseplate