User's Manual Part 2

STRATEGIC Technologies Inc. Passive Mode Installation
Passive Mode Installation
These instructions should be used if the participant is to be monitored without the use of a phone
line in the participant’s residence. The PRU+ needs to be downloaded on a regular basis so that
the stored events can be viewed.
Pre-Installation
A. If your equipment is monitored by our Monitoring Center:-
- Fax the Enrollment Form to the Monitoring Center, giving as much time as possible (½
hour minimum) before the unit is to be hooked up to an participant. The Monitoring Center
must be notified before the unit calls in.
B. If you monitor your own equipment:-
- Assure you have entered the participant data on your system before you proceed with the
installation. The curfew call back ranking should be set to ‘0'.
PRU Installation - Quick Install
Use this method if you are going to use the Quick Install Feature found in firmware version 2.1.
1. Plug in the PRU+: Plug one end of the AC Adapter into a 110 Volt AC Outlet and the other
end into the PRU+. The PRU+ will turn on, displaying the title screen. It will then display the
date and time screen. The power and charge LED will be lit. The charge LED will go out when
the unit is fully charged.
2. Clear Stored Events: Press and hold the PRU+ button on the LOCK until the PRU+
prompts “Please Wait....”. When the display prompts “B=Function Mode” press B button once.
The display will prompt “B=Clear Events”. Press B the display will now prompt A=** Clear ** /
B=Cancel. Press A to clear all events.
3. Enter Quick Install: Press A button once. When the display prompts “B=Quick Install”, press
the B button to enter Quick Install. Follow the messages on the top line. Plug the telephone
line into the jack marked LINE on the back of the PRU. The display will then prompt “Waiting
for PID”
PID Installation
4. Install the Battery: Remove the PID , baseplate, one strap, one locking bar, one locking pin
and the battery from the case. Simply place the battery into the PID battery well so that the
alignment mark on the battery lines up with the alignment mark on the PID. Rotate the battery
counterclockwise until the tabs on the battery slide under the two lock down posts. (See Figure
3 : installing the battery in the PID).