User's Manual Part 2

STRATEGIC Technologies Inc. Active Mode Installation
6. Size the Strap: Attach the wide end of the strap to the PID baseplate. With the baseplate on
the outside of the leg, wrap the strap around the participants leg, just above the ankle. Size the
strap so that it fits comfortably around the participant’s leg. Cut off any access strap that is
above the two hole positions that will fit into the other side of the strap (See Figure 4 : Strap
installation)
Figure 4 : Strap Installation
7. Install Strap and PID: Replace the baseplate and strap around the leg, and attach the narrow
end that has been cut to length to the baseplate. Push the PID onto the baseplate at the strap
end. The PID is now hinged to the baseplate. Firmly close the PID and baseplate together by
pushing down on the open end.
Figure 5 : Attach the PID to the baseplate
8. Install Locking Mechanism: Insert the slider bar under the strap into the hole in the side of
the PID (See Figure 6 : Slider Bar) so the end of the slider bar is flush with the strap. Press a
pin through the hole in the strap and into the slider
bar. This locks the PID together.
Figure 6 : Slider Bar