User's Manual Part 3

STRATEGIC Technologies Inc. Domestic Violence Installation
Figure 3: Installing the battery in the PID
6.
Check PID Transmission: Press A twice then hit B to go into Test Mode. Hold the PID and
watch the PRU+ Test Mode Screen for a transmission from the PID. When the signal is
received it should indicate strap sever symbol. The PRU+ should also beep to indicate
the PID has the correct code. When the transmission is received remove the battery by lifting
the battery out of the battery recess in the PID and place it in the plastic container in the
offenders carry / storage case.
Check the Pendant
7. Check the Pendant Transmission: Push both pendant buttons. The Test Mode screen should
indicate a new transmission (with the code matching the pendant) by placing a + to the left of
the code.
Installation Completion
8. Complete the Installation: On the PRU+, press the A button until “B=Exit” is displayed. Press
button B to exit. Connect the phone line to the wall and to the “LINE” jack on the PRU+. The
PRU+ will call the Central Computer. When “Call Successful” is displayed, installation is
complete.
9. Install the offender’s unit: Follow the PRU+ Active Mode Installation instructions (Page 17,
44) for installing the PRU+ / PID set on the offender.