User's Manual Part 3

1. Connect AC Power & Telephone: Connect AC Power to the PRU+ by plugging the AC
adapter into a wall outlet. Connect the telephone into the telephone outlet. The PRU+ should
immediately start to call into the central computer.
2. Wait for “Call Successful”: When the PRU+ indicates “Call Successful” the PRU+ has
transferred all of the stored information. If the PRU+ does not indicate “Call Successful” the
PRU+ needs to call into the CC again. This can most easily be accomplished by removing the
AC plug from the wall until the PRU+ indicates “Starting Call..”. Once the PRU+ indicates
“Telephone In Use” plug the AC adapter back into the wall outlet.
3. Turn the PRU+ Off: Press and hold the PRU+ button on the LOCK until “Please Wait...”
Is displayed on the PRU+. When “A=Turn PRU+ Off” is displayed, press button A on the PRU.
Disconnect the AC adapter from the wall. The PRU+ will turn off in approximately five (5)
seconds.
4. Disconnect the PRU+: Disconnect the AC adapter from the back of the PRU+. Disconnect
the telephone cord from the PRU+ and wall jack. Place the PRU+, AC Adapter and telephone
cord into the carry / storage case.
5. Remove the Pin and Slider Bar: Using a tool such as a small screwdriver, rotate the locking
pin on the PID all the way around two times (in both directions). This will break the locking pin
and will enable the slider bar to be removed.
6. Remove the PID from the Baseplate: Remove the locking pin and slider bar. At the slider
bar end, lift the PID away from the baseplate (like opening a clam shell).
7. Remove the Battery: Remove the battery from the PID by pulling it out of the battery well and
place it in the plastic container in the carry / storage case. DO NOT TRY TO TURN THE
BATTERY.
8. Remove the Strap: Remove the strap from the baseplate. Replace the baseplate back onto
the PID and return the PID to the carry / storage case.