User's Manual Part 3

strap so that it fits comfortably around the participant’s leg. Cut off any access strap that is
above the two hole positions that will fit into the other side of the strap (See Figure 4 : Strap
installation)
Figure 4 : Strap Installation
7. Install Strap and PID:
Replace the baseplate and strap
around the leg, and attach the narrow end that has been cut to
length to the baseplate. Push the PID onto the baseplate at the
strap end. The PID is now hinged to the baseplate. Firmly close the PID and baseplate
together by pushing down on the open end.
Figure 5 : Attach the PID to the baseplate
8. Install Locking Mechanism: Insert the slider bar under the strap into the hole in the side of
the PID (See Figure 6 : Slider Bar) so the end of
the slider bar is flush with the strap. Press a
pin through the hole in the strap and into the slider
bar. This locks the PID together.
Figure 6 : Slider Bar