User's Manual Part 3

STRATEGIC Technologies Inc. Test Mode
Test Mode
Test Mode which is accessed from the Special Function Mode screens is useful for many diagnostic
tests. Selecting test mode causes the screen shown below to be displayed.
Figure 1 : Test Mode Display
The top line of the display is the signal strength of the last transmission received from the PID along
with the channel received.
The left half of the bottom line provides PRU+ status information. The two symbols at the left edge
of the display are status indications:
AC Power - indicates the AC power adapter has been properly connected and
plugged into a standard functioning 110 volt AC electrical outlet.
Telephone Line - indicates that the PRU+ has been connected to a properly functioning
telephone line.
The two symbols to the right of the AC power and telephone indications represent the following
alarm conditions:
PRU+ Tamper - indicates the PRU+ case is open or has been seriously
damaged.
PRU+ Motion - indicates the PRU+ is moving or tilted.
Low PRU+ Battery- indicates that the PRU+'s internal battery is approaching the
limits of sustained operation (applicable only when AC power is not
connected).
The right half of the bottom line provides information on transmissions received from PIDs. The five-
digit number shown is the PID code of the last received transmission (see Note below). If a '+' is
shown next to the PID serial number, this indicates that the transmission was received within the
last 5 seconds. After the + symbol expires, the position on the display will indicate if the serial
number is assigned to either the PID monitored by the PRU+ (a ‘T’ will be displayed) or the
domestic violence pendant (an ‘S’ will be displayed). If the PRU+ button is pressed on the
LOCK the serial number will change to display “LOCK”.