User's Manual Part 3

STRATEGIC Technologies Inc. Extended Special Function Mode
Extended Special Function Mode
Extended Special Function Mode is used to change the internal settings inside the PRU+. The
ability to change the internal settings gives the PRU+ great flexibility. The installer can now change
important settings depending upon their needs.
Extended Special Function Mode can be accessed by moving to the screen “B=Exit” as shown on
pages 36 and 37. To access the extended configuration settings, hold down the PRU button
on the LOCK. Once a small dot begins to flash in the right top corner of the display press the "A"
button. This will cause the PRU+ to display the configuration screen, as shown in the next diagram.
This screen allow the installer to change the way the PRU+ dials. The PRU+ can dial both pulse
and tone. Select the mode that is appropriate for your telephone network. Press the “B” button to
change the dial mode between “T” (tone dialling) and “P” (pulse dialling). Press the “A” button to
move to the next screen.
If the PRU+ is installed in an office or a hotel, the telephone system may require an additional digit
to be dialled to access an outside line. Pressing the “B” button changes the prefix between “N”
which indicates “No Prefix” required to a “digit” from 0 to 9. Stop pressing the “B” button when the
prefix required is reached. Press “A” button to proceed to the next function.
This screen allows the installer to change the telephone number that the PRU+ will dial to call the
Central Computer. When this screen is displayed, pressing the "A" button will move to the next
screen. If the "B" button is pressed, a flashing cursor is displayed over the first character of the
telephone number. This indicates that the display is now in "edit mode". While in edit mode,
pressing the "B" button will change the character under the cursor. Pressing the "B" button
repeatedly will cycle through the valid characters (0-9, a # symbol, a * symbol, a comma - used to
insert a two-second pause into the dialling sequence; or a space - to erase unnecessary
characters). While in the edit mode, pressing the "A" button steps through the character positions
from left to right, until the last (fourteenth) character is reached. At this point, pressing the "A" button
will cause the screen to exit “edit mode” and move to the next option.
A=Next Function
B=Dial Mode T
A=Next Function
B=Dial Prefix: N
A=Next FunctionB#1,8001231234