User's Manual

Test Mode STRATEGIC Technologies Inc

iTRX Series Users Guide (STI) Feb 6, 2004

• The right half of the bottom line provides information on transmissions received from iTXs. The five-

digit number shown is the iTX code of the last received transmission (see Note below). If a '+' is

shown next to the iTX serial number, this indicates that the transmission was received within the

last 5 seconds. After the + symbol expires, the position on the display will indicate if the serial

number is assigned to either the iTX monitored by the ACU (a ‘T’ will be displayed). If the iRX

button is pressed on the LOCK the serial number will change to display “LOCK”.

Note: The test mode will receive and display transmissions from ALL iTX's within range of the ACU. If

a transmission is received from the iTX which is assigned to the ACU, the ACU will beep.

• The next three spaces (indicated by the circled area) provide information on iTX transmissions

• iTX transmission symbols

to the right of the code number provide the following information:

Strap Sever - indicates the last received transmission showed a strap cut alarm.

Strap Tamper - indicates the last received transmission showed a strap tamper

alarm

Low iTX Battery - indicates the battery installed in the device is approaching the limits

of its lifetime or is improperly installed.