User's Manual

STRATEGIC Technologies Inc Test Mode
iTRX Series Users Guide (STI) Feb 6, 2004 31
Test Mode
Test Mode which is accessed from the Function Mode screen is useful for many diagnostic tests.
Selecting test mode causes the screen shown below to be displayed.
Figure 8 : Test Mode Display
Explanation of Test Mode screen
:
• The top line of the display is the signal strength of the last transmission received from the iTX along
with the channel received.
• The left half of the bottom line provides ACU status information. The two symbols at the left edge of
the display are status indications:
AC Power - indicates the AC power adapter is properly connected and plugged
into a standard functioning 110 volt AC electrical outlet.
P AC Power - indicates the AC plug on the back of the ACU has been disconnected.
Telephone Line - indicates that the ACU is connected to a properly functioning
telephone line.
• The two symbols to the right of the AC power and telephone indications represent the following
alarm conditions:
ACU Tamper - indicates the ACU case is open or has been seriously damaged.
ACU Motion - indicates the ACU is moving or tilted.
Low ACU Battery - indicates that the ACU's internal battery is approaching the limits of
sustained operation (applicable only when AC power is not
connected).
+
_