User's Manual

Extended Function Mode STRATEGIC Technologies Inc

iTRX Series Users Guide (STI) Feb 6, 2004

This screen allows the installer to change the leave window for the ACU. The leave window is the

period of time which the ACU allows to elapse without receipt of any transmissions from the iTX before

a "Leave" message (ie ..info leave or ALARM AWAY) is registered. Pressing the "B" button repeatedly

steps through the possible values (3-30). Pressing the "A" button causes the next screen to be

displayed.

A=Next Function

B=ReportMotion = Y

This screen allows the installer to change the motion sensor option for the ACU. The motion sensor

has the ability to determine if the ACU has been moved. Leaving the default value of “Y” will allow the

ACU to report both “Alarm Motion” events as well as “info motion” events. When set to “N”, only “Alarm

Motion” events will be recorded. Pressing the "B" button repeatedly steps through the possible values

(Y-N). Pressing the "A" button causes the next screen to be displayed.

A=Next Function

B=RstBlindDial = Y

This screen allows the installer to change the Blind dial mode for the ACU. Selecting

RstBlindDial = Y

which is the default value, the ACU will begin making calls normally (not blind dialling). If a call attempt

fails due to no dial tone, then the ACU goes into blind dial mode but, after the successful call, blind dial

mode will be turned off. Selecting

RstBlindDial = N, the ACU will begin making calls normally (not

blind dialling). If a call attempt fails due to no dial tone, then the ACU goes into blind dial mode and the

blind dial mode will then be the default value for all subsequent calls until a hardware/software reset.

Pressing the "B" button repeatedly steps through the possible values (Y-N). Pressing the "A" button

causes the next screen to be displayed.

A=Next Function

B=Set Leave: 10