User's Manual

STRATEGIC Technologies Inc Passive Mode Installation
iTRX Series Users Guide (STI) Feb 6, 2004 23
5. Remove the iTX: A pair of #170 shears have been supplied for removing the iTX from the
baseplate. On each side of the iTX are two channels with a small hole at the bottom of each.
Place the points of the shears into the holes and cut the plastic, twisting the shears after making
the cut, prying the iTX away from the baseplate. (See pictures on page 19.) You must cut both
ends in this manner. This will release the baseplate from the iTX. You can now pull the iTX away
from the baseplate and remove the strap from the baseplate. Check that the piece of plastic cut
from the baseplate is removed from the end of the iTX.
L Note: You may choose to skip the next step and leave the battery in the iTX, if you so desire.
6. Remove the battery: Using the plastic turn key, rotate the battery in a clockwise direction from
the ‘C’ to the ‘O’. When the alignment arrow on the battery lines up with the arrow beside the ‘O’
on the iTX the battery is open and can be removed. Use the end of the turn key to gently lift one
edge of the battery up. Remove the battery from the iTX by pulling it out of the battery well.
Replace the battery cover on the battery. Place the battery in the plastic container in the carry /
storage case. It is important that batteries be stored correctly to maintain battery life. DO
NOT STORE BATTERIES TOGETHER WITHOUT THE COVER IN PLACE.