User's Manual

Active Mode Installation STRATEGIC Technologies Inc

iTRX Series Users Guide (STI) Feb 6, 2004

Active Mode Installation

These instructions should be used if the participant is to be monitored via a telephone line in the

participant’s residence. The ACU will call into the Central Computer on a regular basis reporting all

activity.

Pre-Installation

A. If your equipment is monitored by a Monitoring Center:-

- Fax the Enrolment Form to the Monitoring Center, giving as much time as possible before the

ACU is to be installed at a participant’s residence. The Monitoring Center must be notified

before the ACU calls in. See Passive Mode Operation (See Page 20) for more details on

installation of an ACU in a passive monitoring situation.

B. If you monitor your own equipment:-

- Assure you have entered the participant data on your system before you install the ACU in the

participant’s residence. See Passive Mode Operation (Page 20) for more details on installation

of an ACU in a passive monitoring situation.

ACU Installation - Quick Install

1. Position the ACU: Remove the ACU and AC power adapter from the case. Place the ACU in

a central location, preferably closer to the participant’s bedroom than their living area, elevated

at least three feet / ninety centimetres from the floor.

2. Plug in the ACU: Plug one end of the AC power adapter into a standard 110 Volt electrical

outlet and the other end into the ACU. Be sure to screw the AC power connector firmly into the

matching connector on the back of the ACU. Note: Do not connect the telephone line. The

ACU will turn on, displaying the title screen. It will then display the date and time screen. The

power and charge LED will be lit. The charge LED will go out when the ACU internal battery is

fully charged.

3. Clear Stored Events: Press and hold the iRX button on the LOCK until the display

prompts “A=Function Mode”, press “A” button once. The display will prompt “B = Clear

Events”. Press “B”, the display will now prompt “A = ** Clear ** / B=Cancel”. Press “A” to clear

all events.

4. Enter Quick Install: Press “A” button once. When the display prompts “B=Quick Install”, press

the “B” button to enter Quick Install. Follow the messages on the top line. Plug the telephone

line into the jack marked LINE on the back of the ACU. The display will then prompt “Waiting for

PID”