User's Manual

BASIC FUNCTIONS
LOAD
KleeYa - User Manual - Version 2 3-51
b. Tap on the desired set of tests.
The set of tests is assigned to the selected sample, calibrator, or control
and displayed in the table line.
An assigned profile is marked in dark grey in the Profile tab.
c. Repeat the assignment for further set of tests.
5. If necessary, tap on the STAT button to start the test(s) with high priority.
The STAT symbol is displayed in the table line and the STAT button is marked in
dark grey.
A detailed explanation of STAT can be found in chapter 3.4.1 on page 3-43 .
6. Repeat the procedure for other samples, calibrators, or controls.
DILUTIONS It is also possible to change the dilution factor of a sample, calibrator, or control if
the test allows dilution factors:
1. Tap on the desired sample ID, calibrator ID, or control ID.
2. Tap on the Dilutions tab (5) on the right side of the screen.
3. Tap on the desired test.
Figure 3-49: Dilution tab
4. Tap on the desired dilution factor.
The dilution factor is assigned to the selected sample, calibrator, or control.
5. Repeat the procedure for other samples, calibrators, or controls.
CANCEL AN
ASSIGNMENT
Any assignment can also be canceled by selecting it again:
1. If not already selected, tap on the desired sample ID, calibrator ID, or control
ID.
2. Assigned single test(s):
a. Tap on the Group tab (3) on the right side of the screen.
b. Tap on the selection list below the tabs to show a specific group of tests
or all tests.
All already assigned tests are marked dark gray in the Group tab.
c. Tap on the desired test.
The test assignment is canceled.
d. If necessary, repeat the steps for further tests.
3. Assigned set of tests:
a. Tap on the Profile tab (4) on the right side of the screen.
All already assigned profiles are marked dark gray in the Profile tab.