User's Manual

3-50 KleeYa - User Manual - Version 2
BASIC FUNCTIONS
LOAD
3.4.1.2 MANUAL TEST AND DILUTION ASSIGNMENT
It is possible to assign samples, calibrators, or controls manually to one or more
tests. For any loaded sample rack, the sample rack details allow test order
assignment.
In addition, a dilution factor can also be selected for samples, calibrators, or
controls, if dilutions are intended for the respective assay. By default, the smallest
selectable dilution factor (e.g. none - undiluted) is assigned.
Assign single tests or a set of tests?
When assigning tests to a sample, calibrator, or control, you can choose whether to
select individual tests (Group tab (3)) or a whole set of tests (Profile tab (4)). A
profile is a collection of several previously defined tests. With a profile it can be
avoided that a single test is forgotten in case of repeated test requests.
Figure 3-48: Inserted sample racks
1. Tap on the desired sample rack symbol (1).
The user software shows in the middle of the screen all IDs of each test tube
(2).
2. Tap on the desired sample ID, calibrator ID, or control ID.
Assign single test(s) or/and a set of tests:
Already assigned tests are marked dark.
3. Assign single test(s):
a. Tap on the Group tab (3) on the right side of the screen.
b. Tap on the selection list below the tabs to show a specific group of tests
or all tests.
c. Tap on the desired test.
The test is assigned to the selected sample, calibrator, or control and
displayed in the table line.
An assigned test is marked in dark grey in the Group tab.
d. Repeat the assignment for further tests.
4. Assign a set of tests:
a. Tap on the Profile tab (4) on the right side of the screen.