User's Manual

3-48 KleeYa - User Manual - Version 2
BASIC FUNCTIONS
LOAD
Figure 3-47: Sample loading bay
7. Test and dilution assignment:
a. Automatic test and dilution assignment: If the instrument is connected
to a LIS- or LAS-system, the samples will be automatically assigned to one
or more tests, see chapter 3.4.1.1 on page 3-49 .
b. Manual test and dilution assignment: It is always possible to assign
samples to one or more tests manually, see chapter 3.4.1.2 on page 3-50 .
8. If desired, load additional sample tube racks.
9. Close the sample/Anchor® Tips loading bay flap.
UNLOADING
1. Open the sample/Anchor® Tips loading bay flap.
2. Press the unused/finished sample rack a short-time against the pressure of
the spring. The sample rack is set free.
The corresponding LED over the sample loading lane must be off.
3. Remove the sample rack carefully.
4. Close the sample/Anchor® Tips loading bay flap.
Check sample rack
The sample rack should be checked at regular intervals for damages, wear and tear
see chapter 5.2.5 on page 5-10 .