User's Manual

MAINTENANCE AND SERVICE
SERVICE
KleeYa - User Manual - Version 2 5-17
Figure 5-13: Bottom position
5. Make sure that the spacers are pushed to the bottom of the rack and sit plain
inside the rack.
If necessary use the pen, your finger or a sample tube and push down the
spacer.
6. Repeat the steps to insert all spacers.
Re-insert the springs into all 12 sample positions:
7. Place the spring into the sample position from above.
Make sure the spring runs under the spring guide when pushing it down. The
spring snaps into place with a click. When correctly inserted the springs are all
at the same height about 1 mm lower than the back of the rack.
Figure 5-14: Insert spring
8. Repeat the steps to insert all springs.