Instructions / Assembly

STEP 1

Take measurement between wall or post at 3 points:

top, middle and bottom.

Take note of the smallest width measurement.

STEP 3

Ax outer frame to post or wall with screws (sold

separately)

STEP 2

Remove top cap and set aside for later use (Do not

remove cap from bottom end of side frame).

Slide out the inner gripping channel.

STEP 4

Slide inner gripping channel back into outer frame

TOOLS REQUIRED FOR INSTALLATION

 METAL TAPE MEASURE

 SPIRIT LEVEL

 PHILLIPS HEAD SCREWDRIVER BIT FOR DRILL

 CARPENTERS PENCIL

 POWER AND/OR CORDLESS DRILL

 TIMBER, MASONRY OR STEEL DRILL BITS AS NEEDED

 DROP SAW WITH SUITABLE BLADE FOR CUTTING ALUMINIUM IF ADJUSTING HEIGHT OR WIDTH

NOTE

If installing screen in

area where gripping

channel cannot be

removed (e.g. close to

underside of roof line),

simply drill large pilot

hole through inner

gripping channel to

allow screws to pass

through and ax outer

frame directly to wall

or post.

SIDE FRAME

ASSEMBLY GUIDE

PAGE 1
SIDE FRAME ASSEMBLY GUIDE TOOLS REQUIRED FOR INSTALLATION • METAL TAPE MEASURE • SPIRIT LEVEL • PHILLIPS HEAD SCREWDRIVER BIT (FOR DRILL) • CARPENTERS PENCIL • POWER AND/OR CORDLESS DRILL • TIMBER, MASONRY OR STEEL DRILL BITS (AS NEEDED) • DROP SAW WITH SUITABLE BLADE FOR CUTTING ALUMINIUM (IF ADJUSTING HEIGHT OR WIDTH) STEP 1 STEP 2 Take measurement between wall or post at 3 points: top, middle and bottom. Take note of the smallest width measurement.
PAGE 2
SIDE FRAME ASSEMBLY GUIDE 1” (25mm) total deduction (cut one end only) Rotate block for 3/8” (9mm) or 13/16” (20mm) spacing STEP 5 STEP 6 Cut aluminium slats 1” (25mm) less than total width of opening. Refer to measurement in step 1. The 1” (25mm) deduction takes into account thickness of side frame on both sides of the screen. Push slats down into side frame ensuring spacer blocks are placed between each slat.