User's Manual

Using Objet Studio
5–52
DOC-06800 Rev. A
Model Material
Substitution
Figure 5-72: Model Material Substitution dialog box
If you allow the use of substitute model materials, the printer will use
different materials whose characteristics (strength, flexibility, etc.) are
similar to those of the material you assigned to the object when
designing the build trayunder the following conditions:
•
The material you assigned is not installed in the printer at the time
of printing.
In this case, the tray is printed with either one or two substitute
materials (depending on the materials installed in the printer at the
time of printing). If possible, High Speed mode is used.
•
In addition to the material you selected, there is another (similar)
material installed in the printer at the time of printing.
In this case, High Speed mode is used, by printing with a mixture of
the two materials (as if they were the same material).
D R A F T
16 June
2013