User's Manual

DOC-06800 Rev. A
5–45
Objet1000 - Connex 2 User Guide
To use polygon reduction:
1. From the Tools menu, select
Options
.
or
In the Objet Studio Commands Menu, click
Options
.
2. In the Options dialog box, display the
Display
tab.
Figure 5-64: Options dialog box, Display tab
3. Select
Enable Polygon Reduction
.
4. Select
Polygon Reduction (Percent)
.
5. Enter the percentage of total polygons to display.
When you click
Apply
, the display changes.
Note: The setting affects the static display (when the object is not being
moved).
6. Set display options when the object is being moved (Display while
changing view):
•
Bounding BoxA box representing the objects maximum
dimensions is displayed.
•
Adaptive Polygon ReductionVarying degrees of polygon reduction
are applied, as necessary.
•
Entire ObjectNo polygon reduction is applied.
7. To save these settings, so that they will be applied every time you place
this object on the build tray, click
Save Polygon Reduction Data
.
8. Click
Apply
to see the results of the settings without closing the dialog
box.
Selecting the Entire Object option cancels polygon reduction.
D R A F T
16 June
2013