User's Manual

DOC-06800 Rev. A
5–33
Objet1000 - Connex 2 User Guide
3D files contain an object s proportions, but not its units of measure.
Therefore, make sure to correctly select either millimeters or inches when
inserting an object. Otherwise, the size of the object on the build tray will be
either much too large or much too small.
To set the measurement units when inserting an object:
In the Insert dialog box, Units field, select
Millimeter
or
Inch
:
Figure 5-38: Units field in the Insert dialog box
To change measurement units for a selected object from the
Model Settings ribbon:
1. Open the Units flyout toolbar.
Figure 5-39: Units flyout toolbar
2. Select the measurement units desired.
To change measurement units for a selected object from the Standard
Toolbar:
1. From the Object menu, select
Change Units
.
Figure 5-40: Model Units dialog box
2. In the Model Units dialog box, change the setting and click
OK
.
D R A F T
16 June
2013