User's Manual

DOC-06800 Rev. A
2–7
Objet1000 - Connex 2 User Guide
Waste Disposal
Fully cured printed models can be disposed of as ordinary office trash.
However, special care is required when handling printer waste.
When removing the waste container from the Objet printer, wear
neoprene or nitrile gloves.
To prevent liquid waste from splashing into the eyes, wear safety
goggles.
Liquid waste from the Objet printer is classified as hazardous industrial
waste. Therefore, printing material waste must be packaged and
disposed of in a manner that prevents human contact with it and
contamination of water sources.
Empty model material and support material cartridges contain residue
of their contents. Some leakage of this residue may occur through the
broken cartridge seal. Therefore, handle and store empty cartridges
with care.
Do not attempt to reuse empty cartridges, and do not puncture them.
Dispose of used cartridges and waste containers in accordance with
local regulations.
Discard contaminated clothing, shoes, empty containers, etc., in
accordance with any applicable regulations.
D R A F T
16 June
2013