User's Manual

DOC-06800 Rev. A
6–53
Objet1000 - Connex 2 User Guide
Replacing the
Waste
Container
Printer waste contains partially cured polymeric material, collected during
normal operation and maintenance of the printer. For safety and
environmental reasons, this material is kept in leak proof containers.
monthsEach container has a capacity of 18 kilograms of waste material.
The printer software displays a warning message when one waste
container is full and there is XX kilograms of material in the other container.
The printer stops printing when the net weight in the second container
reaches XX kilograms. When the net weight in the second container is
above XX kilograms, the software does not allow you to start a print job (or
a printing activity) until you replace one of the waste containers. You can
monitor the weight of the waste containers in the printer interface.
.
Cleaning the
Exterior Panels
The painted exterior plastic panels of Objet 3D printers have a durable
finish, offering excellent chemical resistance to common cleaning materials.
However, it is recommended that you use only a mild soap solution for
routine cleaning.
Dispose of the full waste container in accordance with environmental and
safety requirements.
D R A F T
16 June
2013