User's Manual

DOC-06800 Rev. A
6–49
Objet1000 - Connex 2 User Guide
Running Tests
To run the selected tests:
Click .
Test Results
To save and view a report of all of the tests:
Use the Save and View command buttons (see below).
Unknown
Click to select all test that have not been run yet (Status = ?).
Group
Use this menu to select tests by component category.
Selection
Set
Use this menu to select a pre configured set of tests to run at
specified times (computer startup, before printing, etc.).
After you run a test, the Save and View command buttons are added to the
Built In Tests screen (see below).
D R A F T
16 June
2013