User's Manual

Operating & Maintaining the Objet1000 - Connex 2 3D Printer
6–48
DOC-06800 Rev. A
Test Interface The Built In Tests screen lists pre configured tests, grouped by component
categories. In this screen, you select and run tests, and the results are
displayed.
Figure 6-69: Built In Tests screen
Test List
Test Name
This column lists all of the tests, together with selection check boxes.
Click the check boxes to select the tests you want to run. To remove a
selection, click the check box again. To quickly select all of the tests in a
component category, use the Group pull down menu at the bottom of the
screen.
Group
This column shows the component categories for each test.
This tells you which tests are run when selecting a category from the Group
pull down menu at the bottom of the screen.
Status
This column shows the results of each test after you run it:
Test Selection Area In the Test Selection area, at the bottom of the screen, you can quickly select
or de select tests by their characteristics:
Test successfully completed.
Test failed.
Unknown results. (The test has not been run yet.)
All
Click to select all of the tests in the list.
None
Click to de select all of the tests in the list.
D R A F T
16 June
2013