User's Manual

Operating & Maintaining the Objet1000 - Connex 2 3D Printer
6–46
DOC-06800 Rev. A
The wizard operates the lamps and checks if their power is within the
acceptable range for each printing mode. (The mode currently being
checked appears in the lower left corner of the printer interface.)
Figure 6-66: Status screen during UV lamp check
14. After replacing a UV lamp, it is recommended that you calibrate its
power for the various printing modes. The final screen allows you to
continue to the UV Calibration Wizard (see Testing and Calibrating
the UV Lamps on page 6 36).
Figure 6-67: Final wizard screen
D R A F T
16 June
2013