User's Manual
Operating & Maintaining the Objet1000 - Connex 2 3D Printer
6–44
DOC-06800 Rev. A
7. Pull the lamp reflector out of the print block.
Figure 6-61: Removing the UV lamp reflector
8. Inspect the new lamp reflector, and make sure that a black strip is
attached to the inside of it. If not, install oneon the side of the
reflector opposite (not next to) the print block.
Note: Extra black strips are included in the printer Start-up Kit. If
necessary, you can remove the black strip from the old reflector and install
it in the new reflector (as long as the black paint has not faded).
9. Discard the old reflector and lamp.
10. Insert the new UV lamp/reflector unit into the housing next to the print
block.
Figure 6-62: Print block and UV lamp assembly, showing correct placement of
black strip
Dispose of the used UV lamp in accordance with environmental and safety
requirements.
Black strip
UV lamp
assembly
Black strip
UV lamp
assembly
D R A F T
16 June
2013