User's Manual

Operating & Maintaining the Objet1000 - Connex 2 3D Printer

6–40

DOC-06800 Rev. A

After examining the UV calibration results:

1. Click

Figure 6-52: Final UV Calibration Wizard screen

Calibrating the

Load Cells

Load cells are sensors that measure the weight of the printing cartridges

and the waste container in the printer. It is important that you periodically

check that the weight measurements are accurate, both for convenience and

to prevent unnecessary waste of printing materials. It is recommended that

you calibrate the load cells once a month.

To calibrate load cells:

1. Start the Load Cell Calibration Wizard from the Options menu (see

figure 6 24 on page 25).

2. Make sure that there are no containers on the load cells that you want

to calibrate, select the appropriate check boxes in the wizard screen,

and click

Figure 6-53: Load cell selection

D R A F T

16 June

2013