User's Manual

DOC-06800 Rev. A
6–37
Objet1000 - Connex 2 User Guide
To test and calibrate UV lamp radiation:
1. Start the UV Calibration Wizard from the Options menu (see figure 6 24
on page 6 25).
2. If the following screen appears, select
UV Power Calibration
to adjust
the power supplied to the UV lamps so that the UV radiation is within
the acceptable range.
Figure 6-46: UV Test/Calibration selection
3. Make sure that the build tray is clear (empty), and close the printer
cover. Confirm this in the wizard screen and click
Next
.
Figure 6-47: Printer preparation
D R A F T
16 June
2013