User's Manual

DOC-06800 Rev. A
6–33
Objet1000 - Connex 2 User Guide
8. When the following screen appears, remove the transparency.
Figure 6-40: Head Alignment Wizard—steps 8–10
The transparency sheet is printed with sets of vertical lines in seven
columns, each showing the results from a different print head.
Figure 6-41: Sample head-alignment test
•
The three columns on the right were printed by the heads used for
applying Model material when producing models. From right to
left, the columns represent heads M1, M2, M3, respectively. (There
is no column for head M0 because its alignment is used as a
reference for aligning all other heads.)
•
The four columns of lines on the left were printed by the heads used
for applying Support material. The columns represent heads S3, S2,
S1 and S0, respectively.
D R A F T
16 June
2013