User's Manual

DOC-06800 Rev. A
6–29
Objet1000 - Connex 2 User Guide
6. Before returning the roller waste collector to the print block, make sure
that the pins are clean.
Figure 6-32: Roller waste collector pins
7. Return the roller waste collector to the print block and screw on the
covering (see figure 6 30 on page 6 28).
8. Loosen the screws securing the suction tube.
Figure 6-33: Suction tube correctly positioned
9. Lower it so that the hole in the panel behind the suction tube is visible,
and tighten the screws to secure the tube.
10. Attach the right UV lamp assembly to the print block and reconnect
the UV power and fan cables.
Replacing the
Roller Scraper
You should replace the roller scraper blade:
•
after 1,000 hours of printing.
•
if it does not effectively keep the roller clean.
To replace the roller scraper:
1. Prepare
•
a new roller scraper (knife) (KIT 01026 S)
•
a Phillips 1x75 mm screwdriver
•
M2.5 and M2 Allen keys
2. Remove the right UV lamp and the roller waste collector covering (see
steps 3 to 6 on page 6 27.)
Roller waste
collector pins
Securing screws
You should periodically test the effectiveness of the roller scraper when you
clean the roller waste collector. See “Cleaning the Roller Waste Collector
and Inspecting the Roller Scraper” on page 27..
D R A F T
16 June
2013