User's Manual
DOC-06800 Rev. A
6–23
Objet1000 - Connex 2 User Guide
Pattern Test
The pattern test is the basic verification of the printers ability to produce
quality models, since it demonstrates the condition of the nozzles in the
print heads. Make sure, therefore, that you perform this test weekly, and
whenever you suspect a printing problem.
To perform the pattern test:
1. Make sure that the build tray is empty.
2. Prepare a sheet of pink paperA 4 or Letter size.
3. In the printer, tape the pink paper to the surface left of the build tray.
4. Press
F3
, or open the Options menu and select
Pattern Test
.
Figure 6-21: Pattern Test confirmation
5. If the build tray is not clear, click
No
in the following dialog box.
This lowers the build tray, so that models on the tray are not damaged.
Figure 6-22: Build tray (Z) level adjustment
The printer prints a series of lines on the test paper (see next figure).
Figure 6-23: Sample Pattern Test
6. Carefully inspect the test paper to see if there are missing lines.
Too many missing lines, especially if they are in the same area,
indicates that the quality of printing when producing models will be
poor. If this is the case, see Improving Print Quality, below.
Note: Acceptable model quality is subjective, and depends on the type
and scale (size) of the models produced. As a rule, however, more than 10
missing lines in one area of a column is considered unacceptable.
D R A F T
16 June
2013