User's Manual

Operating & Maintaining the Objet1000 - Connex 2 3D Printer
6–8
DOC-06800 Rev. A
Printing
Indicators
The printer interface screen changes when you send a print job from Objet
Studio to the printer, and the printer is on line (see figure 6 5):
•
The mode changes from Pre print to Printing.
•
The specific activity being performed is shown in the current activity
field.
•
Current job printing information is displayed.
•
The printing progress bar is displayed.
•
The Stop and Pause buttons are enabled.
When the weight of a cartridge drops below 100 grams, the display of the
material level in the printer interface is red.
Figure 6-5: Printer interface during printing
Progress bar
Pause button
Stop button
Printer mode
Job information
Job information
Current Activity
D R A F T
16 June
2013