User's Manual

Operating & Maintaining the Objet1000 - Connex 2 3D Printer
6–6
DOC-06800 Rev. A
The Objet1000 Connex 2 printer uses one or two Model material
cartridges and one Support material cartridge to produce models. If
additional cartridges are installed and they are not needed for the current
print job, the printer interface indicates which are being used:
•
Blue cartridgeused for the print job
•
Gray cartridgenot used for the print job
You can monitor printer status indicators by switching the printer interface
display. To do this, click the display toggle button in the printer interface
screen.
Figure 6-4: Printer indicators
Temperature.
in front of
print block
Temperature
behind
print block
Chamber temp.
Display
toggle button
Printer set to
online mode
(green)
Temp. of each
Support head
Evacuation
Left UV lamp
Right UV lamp
Temp. of each
Model head
Support/Model
material in print-
block reservoir
System
vacuum level
Temp. of material
pre-heaters
D R A F T
16 June
2013