User's Manual

Operating & Maintaining the Objet1000 - Connex 2 3D Printer
6–2
DOC-06800 Rev. A
Figure 6-1: The Objet1000 3D Printer
Starting the Objet1000 Printer
1. Turn on the main power switch, located at the back of the printer.
Figure 6-2: Main power switch
Turning on the printer also turns on the two built in computers.
CAUTION!
•
Do not attempt to operate the Objet printer before being trained by a
Stratasys customer-support representative.
•
Observe all safety warnings and follow the safety guidelines described
in chapter 2.
D R A F T
16 June
2013