User's Manual

Using Objet Studio
5–76
DOC-06800 Rev. A
Setting the
Remote Printer
Connection
(Client Mode)
When you open Objet Studio for the first time in a client installation, you
are prompted to connect to an Objet server computer that sends jobs to a 3D
printer. To do this, the server computer must be operating and connected to
the local network.
To set (or change) the connection to the server-computer:
1. On the Job Manager ribbon, in the 3D Printer group, click .
2. Enter the name of the server computer or its IP address, or click
Browse
to find and select it.
3. Click
OK
.
Figure 5-109: Printer Server Connection dialog box
Job Manager
Commands
The Job Manager ribbon has three icon groups:
•
3D Printer
•
Queue
•
Job
Figure 5-110: Job Manager ribbon commands
Icons are enabled or disabled according to their relevancy. For example,
you cannot stop printing a job that is not being printed, so the Stop
command is disabled.
D R A F T
16 June
2013