User's Manual

Using Objet Studio
5–74
DOC-06800 Rev. A
Setting the
Printer
Connection
When an Objet 3D printer is installed, the server computer is connected to
that printer. Normally, there should be no reason to change this connection.
Occasionally, however, you may need to reset the connection, to connect
the server to another printer, or to use Objet Studio in off line mode
(without a printer connection).
To set (or change) the printer connection:
1. On the Job Manager ribbon, in the 3D Printer group, click .
2. In the Set Printer dialog box, click
Connect
.
Figure 5-103: Connecting to a printer (A)
3. Enter the computer name or its IP address, or click
Browse
to find and
select it.
Figure 5-104: Connecting to a printer (B)
4. Click
OK
.
When the connection is established, Objet Studio is configured to
prepare print jobs for that printer.
Objet Studio is connected to the printer if you can see the material levels in
the Job Manager screen (see figure 5-102 on page 72).
D R A F T
16 June
2013