User's Manual
Table Of Contents
- Operating & Maintaining the Connex500/350 3-D Printer
- Starting the Connex Printer
- Loading Model and Support Cartridges
- Producing Models
- Resuming Production After Printing has Stopped
- Changing the Model Material
- Keeping the Connex Printer in Idle Mode
- Shutting Down the Connex Printer
- Maintaining the Connex Printer
- Routine Maintenance Schedule
- Cleaning the Print Heads
- Pattern Test
- Improving Print Quality
- Cleaning and Replacing the Wiper
- Cleaning the Roller Waste Collector and Inspecting the Roller Scraper (Knife)
- Replacing the Roller Scraper (Knife)
- Aligning the Print Heads
- Calibrating Print Heads
- Replacing Print Heads
- Testing and Calibrating the UV Lamps
- Calibrating the Load Cells
- Replacing the Odor Filter
- Replacing the UV Lamps
- Built-in Tests
- Replacing the Waste Container
- Cleaning the Exterior Panels
- Handling Printed Models
Operating & Maintaining the Connex500/350 3-D Printer
7–54
DOC-13000 Rev. E
5. DisconnectthepowerconnectiontotheUVlamp.
Figure 7-86: Disconnecting the UV lamp
Note: Do not disconnect the power connection to the cooling fans.
6. LoosenthescrewsecuringtheUVlampcover(A),andpullthecover
up
(B),thenout(C).
Figure 7-87: Removing the UV lamp cover
7. Pullthelampreflectoroutoftheprintblock.
Figure 7-88: Removing the UV lamp reflector