User's Manual
Table Of Contents
- Operating & Maintaining the Connex500/350 3-D Printer
- Starting the Connex Printer
- Loading Model and Support Cartridges
- Producing Models
- Resuming Production After Printing has Stopped
- Changing the Model Material
- Keeping the Connex Printer in Idle Mode
- Shutting Down the Connex Printer
- Maintaining the Connex Printer
- Routine Maintenance Schedule
- Cleaning the Print Heads
- Pattern Test
- Improving Print Quality
- Cleaning and Replacing the Wiper
- Cleaning the Roller Waste Collector and Inspecting the Roller Scraper (Knife)
- Replacing the Roller Scraper (Knife)
- Aligning the Print Heads
- Calibrating Print Heads
- Replacing Print Heads
- Testing and Calibrating the UV Lamps
- Calibrating the Load Cells
- Replacing the Odor Filter
- Replacing the UV Lamps
- Built-in Tests
- Replacing the Waste Container
- Cleaning the Exterior Panels
- Handling Printed Models
Operating & Maintaining the Connex500/350 3-D Printer
7–52
DOC-13000 Rev. E
4. Inthenextwizardscreen,observethenumbersandwaituntilthelevel
isrelativelystable—twounitsaboveorbelowtheaveragelevelshown.
Figure 7-81: Load cell calibration screen
5. SelecttheWeightisstablecheckbox,andclickNext.
Ifyouneedtocalibratemorethanoneloadcell,thenextcalibration
screenappears.Repeatsteps4and5untilalloftheloadcellsare
calibrated.
6. Click
Doneinthefinalwizardscreen.
Figure 7-82: Final wizard screen
Replacing the
Odor Filter
TheConnex500/350printerhasanactivated‐carbonfilterforremoving
odorsfromprintingmaterials.Thefiltershouldbereplacedregularly
(aboutonceayear,asnecessary)tokeepyourworkingenvironment
pleasant.Thisisnormallydoneduringtheyearlypreventive‐maintenance
servicevisit.
Replacing the
UV Lamps
TheUVlampsusedforcuringmodelshavealong,butlimited,working
life.TheObjetserviceengineerteststheireffectivenessduringregular
maintenancechecks,andreplacesthem,ifnecessary.Youcantestand