User's Manual
Table Of Contents
- Operating & Maintaining the Connex500/350 3-D Printer
- Starting the Connex Printer
- Loading Model and Support Cartridges
- Producing Models
- Resuming Production After Printing has Stopped
- Changing the Model Material
- Keeping the Connex Printer in Idle Mode
- Shutting Down the Connex Printer
- Maintaining the Connex Printer
- Routine Maintenance Schedule
- Cleaning the Print Heads
- Pattern Test
- Improving Print Quality
- Cleaning and Replacing the Wiper
- Cleaning the Roller Waste Collector and Inspecting the Roller Scraper (Knife)
- Replacing the Roller Scraper (Knife)
- Aligning the Print Heads
- Calibrating Print Heads
- Replacing Print Heads
- Testing and Calibrating the UV Lamps
- Calibrating the Load Cells
- Replacing the Odor Filter
- Replacing the UV Lamps
- Built-in Tests
- Replacing the Waste Container
- Cleaning the Exterior Panels
- Handling Printed Models
DOC-13000 Rev. E 7–45
Connex500/350 User Guide
16. Pushtheheadupuntilyouhearitclickintoplace,inbothfrontand
rearholders.
Figure 7-68: Clicking the head into place in the print block
17. Lowerthedooroftheprintheadcompartment,andtightenthescrews
tolockitinplace.
18. Tightentheupperandlowerscrewsthatsecuretheprintheadinthe
printblock(seefigure 7‐61onpage 42).
Note: Hand-tighten these screws. Do not use a screwdriver.
19. W ithyourfingers,makesurethatthenewheadislevelandevenwith
theotherheads.
Figure 7-69: Checking the level of the new head
20. Confirmthatthe headsarelevelandevenbyselectingthecheckboxin
thefollowingwizardscreen,andclick
Next.