User's Manual
Table Of Contents
- Operating & Maintaining the Connex500/350 3-D Printer
- Starting the Connex Printer
- Loading Model and Support Cartridges
- Producing Models
- Resuming Production After Printing has Stopped
- Changing the Model Material
- Keeping the Connex Printer in Idle Mode
- Shutting Down the Connex Printer
- Maintaining the Connex Printer
- Routine Maintenance Schedule
- Cleaning the Print Heads
- Pattern Test
- Improving Print Quality
- Cleaning and Replacing the Wiper
- Cleaning the Roller Waste Collector and Inspecting the Roller Scraper (Knife)
- Replacing the Roller Scraper (Knife)
- Aligning the Print Heads
- Calibrating Print Heads
- Replacing Print Heads
- Testing and Calibrating the UV Lamps
- Calibrating the Load Cells
- Replacing the Odor Filter
- Replacing the UV Lamps
- Built-in Tests
- Replacing the Waste Container
- Cleaning the Exterior Panels
- Handling Printed Models
DOC-13000 Rev. E 7–39
Connex500/350 User Guide
However,ifthewizarddeterminesthataprintheadisfaulty—orthatit
isnegativelyaffectingmodelqualitywiththecurrenthead
configuration—thewizardinstructsyoutoreplaceit.Inthiscase,the
followingscreenappears.
Figure 7-56: Defective print heads found
18. ChooseReplacedefectivehead(s)ifyouarepreparedtoreplacetheprint
headsnow.
or—
ChooseAbortwizardifyouwanttoreplace theprintheadsatanother
time.
Ifyouarereplacingtheprintheadsnow,thewizardguidesyouthroughthe
procedurewhenyouclick
Next.Continuewith“Preparingtheprint block”
onpage 41.
Replacing print heads is expensive. Replace them only after consulting with
an Objet-authorized customer-support engineer.