User's Manual
Table Of Contents
- Operating & Maintaining the Connex500/350 3-D Printer
- Starting the Connex Printer
- Loading Model and Support Cartridges
- Producing Models
- Resuming Production After Printing has Stopped
- Changing the Model Material
- Keeping the Connex Printer in Idle Mode
- Shutting Down the Connex Printer
- Maintaining the Connex Printer
- Routine Maintenance Schedule
- Cleaning the Print Heads
- Pattern Test
- Improving Print Quality
- Cleaning and Replacing the Wiper
- Cleaning the Roller Waste Collector and Inspecting the Roller Scraper (Knife)
- Replacing the Roller Scraper (Knife)
- Aligning the Print Heads
- Calibrating Print Heads
- Replacing Print Heads
- Testing and Calibrating the UV Lamps
- Calibrating the Load Cells
- Replacing the Odor Filter
- Replacing the UV Lamps
- Built-in Tests
- Replacing the Waste Container
- Cleaning the Exterior Panels
- Handling Printed Models
Operating & Maintaining the Connex500/350 3-D Printer
7–36
DOC-13000 Rev. E
7. Whenthefollowingscreenappears,cleantheprintheads.
Figure 7-50: Clean print heads screen
8. Placethemirroronthebuildtray.
9. Putonthecleaninggloves.
10. Soakthecleaningclothwiththecleaningfluid(alcohol).
11. Cleantheorificeplates,withaback‐and‐forthmotion.
Figure 7-51: Cleaning the print heads
Usethemirrortomakesurethatyouhaveremovedalloftheresidue
material.
12. Whentheprintheadsareclean,selecttheconfirmationcheckboxin
thewizardscreenandclick
Next.
13. Removethecleaningmaterialsfromtheprinter,andclosethecover.
14. Selecttheconfirmationcheckboxinthewizardscreenandclick
Next.
WARNING: The print head orifice plates (bottom surface) may be hot.
Do not touch them with your bare hands, and proceed with caution.